fadec error problem
 

xicoy fadec error on display, rc signal lost/ incorrect does this mean I need to relearn rc? it was working fine but i relocated the unit so i could get to it easier. also in the wording of instalation reads keep all connections well isolated between them refering to the pump and battery connectons. does that mean keep the battery cables away from the pump cabeles and buy how much thanks
Arden

RE: fadec error problem
 

You are not reciving signal from the RX, check the conections.

Regards

RE: fadec error problem
 

i checked that by puting a servo an the throttle servo cable worked ok rpm ok egt reading 20c
arden

RE: fadec error problem
 

Try checking the connections at the fadec. It's real easy to get the throttle cable plugged in backwards where the signal and - are reversed.

RE: fadec error problem
 

Are you using a 2.4 GHz radio or 72 MHz?

If running a 72MHz the I.C.S. will do strange thing if you get the transmitter too close to it....

RE: fadec error problem
 

Check to make sure that the throttle cable is not backwards -

- next re-learn the TX. Make sure you are pushing the + button instead of the Up arrow when learning. If you don't press the + button the unit WILL NOT retain the settings when you go to the next step.

Andy

RE: fadec error problem
 

Almost sure the throttle cable is reverse to the ECU, follow the color code or you could press the up arrow button to show the receiver voltage or move your throttle stick and watch the top right side % number.