JetCat V10 ECU Rx voltage question
As I'm not getting a response from JetCat in the Direct Support Forum, I'm re-posting here hoping for better luck.
I did some searching in the JectCat V10 ECU manual and on the forums but couldn't find a definitive answer. Can I run the V10 ECU in a high voltage Rx/servo setup, i.e. running 7.4V nominal from a 2S Lipo from the Rx into the Throttle/Aux inputs on the ECU? I would expect I can but want to make sure. Specifically note that my question is *not* about the ECU power itself (running the 3S LiFePo as supplied by Jetcat there). Thanks, Hans. |
RE: JetCat V10 ECU Rx voltage question
Hans
Yes, no problem using HV setup on the Rx (so up to 8.4v control) on a V10 ECU regards Dave |
RE: JetCat V10 ECU Rx voltage question
Thanks Dave! Much appreciated!
|
Dave , how about the Jectcat V5.0 ECU ?, I am planing to feed the receiver & servo with 2S (7.4) for my PHT3 (HP5) , running 7.4V nominal from a 2S Lipo from the Rx into the Throttle/Aux inputs on the V5.0 ECU.
Thanks George |
George
Yes, every ECU from a V 4.9 is suitable for HV operation on Rx Regards Dave |
Excellent Dave, Thanks a lot for this information!!:)
|
All times are GMT -8. The time now is 02:43 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.