![]() |
Good! Maybe I can get some control throw recommendations from another owner. This is my first delta / canard ship.
|
Originally Posted by acw
(Post 12797405)
Take a look at the red cap inside. If it is like mine, you will see the top phillips screw going through the plastic without anything to make it air tight. This is an air leak waiting to happen.
|
Did you already fly the plane?
I have build the first version from JMB and have +50 flights logged and it's a very nice airplane. I can measure the throws and CG next week if you still need it. |
I'm about to maiden in the next week or so. Interested in hearing about your CG and control throws if possible.
https://cimg6.ibsrv.net/gimg/www.rcu...4096c0c4df.jpg This the CG provided by WindRC. |
6 Attachment(s)
The CG is correct on the drawing and the throws are:
•Rudder Parameter : •canard +-15mm •aileron+-25mm •rudder+-25mm •elevator +-30mm I used the settings from the original manual from Aviation Jet (with a little less on the canard) - please see attachment |
Thanks Helifut. I'll compare to my setup.
|
Thanks for sharing!
I’ve been looking at this Rafale for years. I planned on doing a twin SU to harrier around, but this will do it for a lot less $$$ & complexity. How did the maiden & following flights go? What’s your current thoughts?
|
Rafale Maiden Flight
Well, got distracted with other stuff but finally buckled down and got the Rafale to it's maiden flight yesterday. It was an uneventful, easy, stable flight. Very little trim change, a couple of clicks of aileron and elevator. Set up 3 control rates, started in mid and wound up in low. Responsive aileron and elevator but not tricky in any way. Achieved very stable hands off level flight quickly with the CG at factory recommended. Will get into some rolls and knife edge next to sort out couplings and CG adjustments in the next several flights. Going to be fun. Rafale has a great presence on the ground and in the air with that big delta wing like few other RC jets.
https://cimg8.ibsrv.net/gimg/www.rcu...206b2fdcdf.jpg https://cimg1.ibsrv.net/gimg/www.rcu...db8691b19b.jpg |
VERY NICE, Chris!! Looking forward to seeing you in a few weeks at the Jet Nationals in KY!
Wayne |
Originally Posted by sewbusy
(Post 12823302)
VERY NICE, Chris!! Looking forward to seeing you in a few weeks at the Jet Nationals in KY!
Wayne |
| All times are GMT -8. The time now is 11:20 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.