ECU SETUP QUESTION
 

HI Guys,
I am just settin up my TITAN ECU for the first time. I have 10x with Spektrum Module and AR9000 RX. I was told to set FS at 100% ATV and Learn RC at 70% RTV (throttle CH)
so
First I did both procedures at 100% ATV and did not get FS.
Then I did as above and now I am constantly getting FS and LED Sequencing.

As you may know, when using spektrum module with 10X u are in PPM mode and the TX FS in not active.


Can someone tell me how to set up FS and Learn RC with 10x with Spektrum Module...
Thanks
Jason

RE: ECU SETUP QUESTION
 

Set the End Points to +/- 100% for the throttle channel.

Put in the Binding plug and learn the failsafe for low throttle / low trim.

Remove binding plug and reset the End Points to +/- 50%.

Learn R/C.

Test failsafe by shutting off the transmitter and making sure you see the 'F' appear on the GSU top center display.

Putting the End Points to +/- 50% still gives you about 500 throttle settings for the total stick travel.

RE: ECU SETUP QUESTION
 

When you Bind the RX to the TX you should set your throttle to the failsafe position. During the binding process the failsafe is set.
learn your ecu at 70% atv and than reset the atv to 100% and bind your TX and RX with the throttle trim down and the throttle stick in the down position.


Alan

RE: ECU SETUP QUESTION
 

Jason

You are leaving the throttle channel end points as set for the learn RC? Do not return them to 100%

regards

Dave