Flash with Crow settings?
Anyone using crow with a Flash? I am not using it, but a couple of us were wondering.
Also, any set-up tips for a friends Flash with a Titan engine? Thanks, Chris |
RE: Flash with Crow settings?
I flew mine with a 120 se and a titan se. Not much difference other then top end speed. Although I could make a slow pass, power up and pull and upline with the titan se.
I don't see any benefit to crow, the Flash slows down to a walking pace for landing with full flaps. |
RE: Flash with Crow settings?
I'm running mine with a Super Eagle, plenty of power and a drop in installation. Ditch the bottom half of the by-pass, the half facing the wing, and you'll notice a nice thrust increase. No need for crow with the Flash, it has a good sink rate with no tendency to float on approach. Reduce the full flap setting 20-25 mm and make sure it is balanced per the manual. Not an incredibly fast jet but it flies on rails!
|
RE: Flash with Crow settings?
I had great luck using the full flap settings in the manual. It took a little down E mixed with full flap.
|
RE: Flash with Crow settings?
Joel
I have heard Eric say the same thing about the lower half of the bypass but what about the duct in front of it. Remove it also or leave it in? Jerry |
RE: Flash with Crow settings?
No ducting+ titan+ 1/4" crow= 250 mph p***y cat
Raf |
RE: Flash with Crow settings?
ORIGINAL: ravill No ducting+ titan+ 1/4" crow= 250 mph p***y cat Raf |
RE: Flash with Crow settings?
I was advised to leave the duct in place so that's what I did. Only question now is when will the Super Flash be available?
|
All times are GMT -8. The time now is 05:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.