Where to get this fitting?????
 

Guys,

I have the Dreamworks glue in fuel fitting and I need a 90 degree barbed fitting so I can properly route the fuel tubing. See pictures...

Can anyone dial me on where to get one?

Thanks!

RE: Where to get this fitting?????
 

I'd say mcmaster-carr would be the best bet..   not sure what the thread sizes are.. if i had to guess, probly a 1/16 NPT?

RE: Where to get this fitting?????
 

Can anyone comment on thread size on the Dreamworks fitting?

RE: Where to get this fitting?????
 

http://www.centralhobbies.com/Fuel/fittings.htm

RE: Where to get this fitting?????
 

http://www.bvmjets.com/Pages/fuelcells1.htm#KA Looks a lot like the one from BVM.

RE: Where to get this fitting?????
 

Take it to your local Fastenal store. They can can get it. www.fastenal.com

RE: Where to get this fitting?????
 

SMC do something which would probably suit, something along these lines possibly....

www.smcetech.com/CC_host/pages/custom/templates/smc_v2/prodtree_product_2.cfm

marcs

RE: Where to get this fitting?????
 

Take all the guess work out save yourself the time. Just call Patty at BVM. I just ordered these pieces for my Skymaster stuff.

have a good one.

Tell your son hi for me. I want to do some helo flying with him when you get up to Montana.


Justin Sands
BVM rep
Team JR/Horizon

RE: Where to get this fitting?????
 

If you have room why not just come off the straight nipple with a little peice of tubing and then a simple 90 from there??
V..

RE: Where to get this fitting?????
 

Justin, where exactly is that 90 degree fitting on the BVM site?

RE: Where to get this fitting?????
 

Take a look at the accessories online section under kevlar tank accessories it shows them there.

RE: Where to get this fitting?????
 

Hey guys, thanks for all the efforts....

I was able to find a brass fitting at the industrial supply house...I will post a picture when I get a chance...

Justin, helo's are loaded. Jake may not make the trip, he has made All-Stars and is headed for the state championship....

RE: Where to get this fitting?????
 

Bandit, I can see the fittings in the picture but the brass 90 degree is not the same as that posted in the first instant - this BVM item is used as the vent in most cases and not to screw into the main tank fitting.
Sorry if I have missed something.

marcs

RE: Where to get this fitting?????
 

For anyone who stills needs these I found them here:

http://www.airpowernet.com/twe3/prod...roducts_id=317

I made my own as required...would have been easier to just buy these but I found them a day too late!

RE: Where to get this fitting?????
 

Dave,

By the way, Steve sent me two to give you.

Chad