Clutch bell and Spur for MGT 4.6
#1
Senior Member
Thread Starter
Join Date: Jan 2007
Location: San Angelo, TX
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Clutch bell and Spur for MGT 4.6
I have been looking for about a half an hour now and I cant find a Spur gear with more than the stock 52 teeth. I can find anything lower than 15t cb(16t is stock).. anyone know where I can find these to work with my mgt 4.6?
#3
Senior Member
Join Date: May 2006
Location: Johnson City, TN
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch bell and Spur for MGT 4.6
Sure does, here's a link to it. Been meaning to order it myself.
http://www2.towerhobbies.com/cgi-bin...?&I=LXKLB1&P=7
http://www2.towerhobbies.com/cgi-bin...?&I=LXKLB1&P=7
#4
Senior Member
Thread Starter
Join Date: Jan 2007
Location: San Angelo, TX
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch bell and Spur for MGT 4.6
yeah I found a savvy 13t cb and then the rrp slipper looks lilke thats might be the best i can get.. that sounds like it will actually work for what i want
#6
Senior Member
Thread Starter
Join Date: Jan 2007
Location: San Angelo, TX
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch bell and Spur for MGT 4.6
uh.. well you'll have to excuse my possible newbness...
Im not going to crawl so much as bash. I looking for low-end torque for better accel and wheelies
Im not going to crawl so much as bash. I looking for low-end torque for better accel and wheelies
#8
Senior Member
Thread Starter
Join Date: Jan 2007
Location: San Angelo, TX
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch bell and Spur for MGT 4.6
well, not really...lol
I can get my mgt to wheelie but it take perfect conditions and a lot of finessing to get it to wheelie.. i figure more low tq would help but I don't really want the top speed dropping below 30... what if i just dropped to the 13t cb with the stock spur?
I can get my mgt to wheelie but it take perfect conditions and a lot of finessing to get it to wheelie.. i figure more low tq would help but I don't really want the top speed dropping below 30... what if i just dropped to the 13t cb with the stock spur?
#10
Senior Member
Join Date: Jan 2006
Location: Portland,
OR
Posts: 2,682
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch bell and Spur for MGT 4.6
Here man, this should help.. [link=http://www.stc007rc.com/M****RUM/MGT_Gearing.htm]MGT gearing calculator[/link], the stock engine tops out at about 32,000 rpm's, max..