wookie_racer

My Feedback: (8)

ok, i have hade my xxx-nt for a little while. i had it tuned good an run through a full tank of gas, but now it cuts out when there is still about quarter of a tank left. what is up with that?

vwalton

it could be because the engine is over heating, is it running very lean?

wookie_racer

My Feedback: (8)

i dont think so but it i running slow too and it dies in idle. also should the cooling head sit about an 1/8 of an ich off the main case?

rushdude

My Feedback: (1)

Yeah, check your low speed needle. Set it about 1 and a half turns out. Than start to tune it.

wookie_racer

My Feedback: (8)

thanks i will do that tomarrow.

losixxx-nt

yeah sounds like a lsn setting

wookie_racer

My Feedback: (8)

also after it stalls it is impossible to get it to start, i mean my fingers are raw from that damn pull start. i liked my HPI .15FE much better, that thing would start with one pull maybe two.

wookie_racer

My Feedback: (8)

the recoil starter feels like it is slipping so i might have to replace that and a new glow plug, the worst part is, is that i ham flat broke and this is the only thig i have to keep me occupied[:@][:@][][&:] that i i need batts for my e xxx-t. i have had enough with this hobby but i love it too much to quit i might have to take a brake for a while until i find a job[:@][:@]

rushdude

My Feedback: (1)

Its most likely your low-speed needle. If .15fe was better to you probably because it doesnt have a low speed on it.