Tech ? about fuel inlet on Nitro engine
01-07-2006 | 10:05 PM
#1
Thread Starter
Junior Member
Joined: Dec 2005
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
From: , WV
Tech ? about fuel inlet on Nitro engine
I just installed a Diablo engine on my XXXNT and the fuel inlet on the carb is in a awkward position.It puts the fuel line very close to the spur gear and I just know it is going to be a problem.Is there any way to move the position without screwing up the carb?
01-07-2006 | 10:50 PM
#2
Senior Member
My Feedback: (3)
Joined: Jun 2004
Posts: 1,630
Likes: 0
Received 0 Likes
on
0 Posts
From: KEWANEE,
IL
RE: Tech ? about fuel inlet on Nitro engine
sure just lossen it and turn it the way you want... a lot of them are not the way you need them from the factory....kinda like the carbs on some need turned around
01-07-2006 | 11:42 PM
#3
Senior Member
Joined: Sep 2005
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
From: scottsdale,
AZ
RE: Tech ? about fuel inlet on Nitro engine
ORIGINAL: zzman
sure just lossen it and turn it the way you want... a lot of them are not the way you need them from the factory....kinda like the carbs on some need turned around
sure just lossen it and turn it the way you want... a lot of them are not the way you need them from the factory....kinda like the carbs on some need turned around
01-08-2006 | 09:32 PM
#6
Senior Member
Joined: Sep 2003
Posts: 1,631
Likes: 0
Received 0 Likes
on
0 Posts
From: ovideo,
FL
RE: Tech ? about fuel inlet on Nitro engine
i had one engine that i couldnt turn it good thing it wasnt that bad of an angle lol
i think it was my ops it was a pos lol
i think it was my ops it was a pos lol
