collet
06-07-2007 | 05:20 PM
#1
Thread Starter
Junior Member
Joined: Jun 2007
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: , FL
collet
i have a O.S engine it's a .18tz-tx and i want to know is there a certain collet to use on it to keep the flywheel from slipping loose? i checked out tower hobbie but os doesn't have one
06-07-2007 | 08:28 PM
#2
Senior Member
Joined: May 2007
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
From: St. Johns,
NL, CANADA
RE: collet
If the collet you have wont grab just sand down the top down a millimeter and sand the little gap in it a bit bigger. Then the collet can go farther into the flywheel and the bigger gap will make it close up more. Worked like a charm for me 
