Hello Everyone

I have a schumacher truck and am having a problem. The controls are fine when engine is not running, as soon as I start the engine I have no control over the servos and its glitching like mad as soon as I shut off the engine again all is ok? anyone know what it could be?

Cheers

Rich

Ps New batteries and crystals made no difference

sounds like your engine is causing a field. or your electronics are loose so it screws up when theres vibration.

Make sure your antenna isn't stripped anywhere and that its not wrapped around anything in the radio box. Did you cut your antenna wire shorter?

You should also have some resistors on the motor to hlp eliminate interference.