when i set my RC10GT2 down on the ground and try to push it, the back wheels are locked, so it wont move.
but when i pick it up and spin the wheels, they spin fine.
it is just the back wheels that dont spin.
also, is there supposed to be bearings on the back wheels?? there are on the front, but not on the back.

so can someone tell me either what is wrong, or if that is what is supposed to happen?
thanks

i think that would happen if your brakes where on. Try to pull the throttle and move the truck. If it moves then our brakes have been dragging and you should fix that be resetting the linkage.

ok, when i pull the throttle, it does move forward. but it does not move when i dont touch anything.
also, it does that alot, but then sometimes it wont to it, like it will move fine on the ground.
idk how to reset the linkage, do can someone tell me how to do that?

Your instruction manual is a great tool for situations like this.