Hi, I am new to RC's so please refrain from flaming if this has been talked about before, I searched but couldn't find anything........

I currently have two RC10GT's and both have an OS Max engine (not sure on exact engine model) and both are roto starts. I would like to convert one of them to pull start, how hard is this to do and what parts would I need to do so, can you please post up how to do this and what exact parts I would need to accomplish this...

Thank You in advance.....

roto start or do they need a stater box? If roto start, all you need is the pull starter. If its a starter box type, then you will need a ne crank, backplate, one way bearing, pull starter, and possibly a new header.

sorry for the confusion but its the one you use with a starter box