RyWal

Hello,I am relatively new to nitro R/C cars, and have just recently unpacked my Duratrax Nitro Evader ST. It has been running good, and I think I might have stripped the threads while tightening the glow plug. Do I need to buy a new engine head, or will I have to buy an entire new engine? If anyone needs more information on the car let me know.
Thanks in advance,
Ryan

pigpen1

My Feedback: (2)

you can buy a new heat sink head just make sure no metal shavings  fell into the engine

proanti1

My Feedback: (2)

A head for an evader engine will cost you close to nothing.

A-sche36

I am looking for evader st parts if you part out the machine. But I'm sure a head would be easy enough to find also. I have a full spare engine but I would not sell just the head off of it. Lmk if you're interested in either parting out or the engine

1QwkSport2.5r

This thread was long dead. Do look at the last time a post was made to the thread. Often, it’s an old thread and the members who contributed to the thread are long gone.

MargueriteFord

ht have stripped the threads while tightening the glow plug. Do I need to buy a new engine head, or will I have to buy a

MargueriteFord

ts if you part out the machine. But I'm sure a head would be easy enough to find also. I have a full spare engine but I would no

1QwkSport2.5r

Replace the head button if you can find one. Good luck on finding one right now.

also, DON’T HAM FIST THE GLOW PLUG! They don’t need to be that tight to seal.