RE: nitro evader problems need help please
 

I got it used, so I dont have any paperwork on it, I guess Im kinda shafted there, I was hoping I would be able to put a rippin motor on it

RE: nitro evader problems need help please
 

geez man... tell ya what, I've got a smallblock chevy engine in the garage, bring your evader over and we'll get 'er mounted..

if you go get yourself an OS .18 cv-rx, you'll have plenty of power, in fact probably too much power. I put one in mine now, I slow down then crack the throttle it stands up on the back tires.. it's a screaming engine.. it's cheaper than the stock DTX engine, and a direct bolt in.. check it out, you'll like it..

RE: nitro evader problems need help please
 

i had the same problem with mine and i put in as O.S. .15 cv x , it is a direct bolt on with no changes and it runs like a swiss watch. and is sick fast. i race gas stadium oval track with it and outrun nitro rustlers

RE: nitro evader problems need help please
 

OS cv .12 .15 .18 will drop right in the evader...the .18 is alotta power probably too much for dirt running if you mainly run on asphault go for the .18 on dirt I'd go for a .15 or .12....they cost like $100....I got a .18 on mine and it's a ripper...not as fast as the Jato but it's snappy...will wheelie at anytime on demand...hell of alot more durable than them duratrax engines also...those are os rejects

RE: nitro evader problems need help please
 

When I had that problem with my evader bx, my pull start would pull very easily after dying out. It turns out my compression dropped too low when the engine heat expanded the sleeve, and then after 15 minutes it would start again once the compression came back up. Maybe you should try to see if you can turn the fly wheel with one finger easily. If you have little or no resistance, try a new piston and sleeve, otherwise, sounds like a plug.

RE: nitro evader problems need help please
 

please help. After i start my nitro evader and start to applie throttle it will freak out and go full throttle with out me giving it any throttle. it will stop if i applie the break. I tried to change all the batteries in it and it still does it. what should i do?

RE: nitro evader problems need help please
 

ok to the first one.. the books information is wrong
the needles should be hs 2.5 -3 and the low should be roughly 2 or less
its stalling because the low side is rich as he77 turn it in gently back it out 1.5 turns and try .. keep an eye on your temps tho

for the last post you have something metal pinging against the motor or exhaust causing it to freak out.. it happened to me
when i first built the roll cage for my evader st the metal cage was vibrating against the muffler and causeing massive radio
interference.. otherwise you may have a bunk servo internal board on the throttle that can cause irratic actions
start by checking for metal to metal contact making vibrations thatd be my guess then find a spare servo
and change that one if it persists then change the reciever .. its all it could be.."as far as a radio problem"

RE: nitro evader problems need help please
 

same for me, can't keep it run once hot, can't keep any idle. i change the piston and sleeve. one break in later, pow! brand new rocket...