RCU Forums - Pull start and Tiger Drive problems

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Nitro Stadium Trucks (https://www.rcuniverse.com/forum/rc-nitro-stadium-trucks-243/)

- - Pull start and Tiger Drive problems (https://www.rcuniverse.com/forum/rc-nitro-stadium-trucks-243/4073919-pull-start-tiger-drive-problems.html)

Maxime

03-23-2006 07:17 PM

Pull start and Tiger Drive problems

I have a problem with my OS 12 CV-X in a xxx-nt . The pull start continually slipped ( the one way bearing ), so I installed a Tiger Drive and still have the same problem. Impossible to start the engine.

Do you have any idea what might cause this? Should I roughen the start shaft on the engine with sand paper so that the one-way grips better? Any ideas?

Thank you!

Blitzz

03-23-2006 08:00 PM

RE: Pull start and Tiger Drive problems

Same problem on my Trx engine just take the bearing off and soak it in WD-40 or any other cleaning greases and then clean it out. This should work....worked for me.

All times are GMT -8. The time now is 09:35 PM.