RCU Forums - Problem with Jato 3.3

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Nitro Stadium Trucks (https://www.rcuniverse.com/forum/rc-nitro-stadium-trucks-243/)

- - Problem with Jato 3.3 (https://www.rcuniverse.com/forum/rc-nitro-stadium-trucks-243/8356313-problem-jato-3-3-a.html)

apax	01-14-2009 03:16 AM

Problem with Jato 3.3

I dont know why my Jato's on board switch wont power the car. The car itself will start with the EZ start but i cant get the darn thing to respond to my Control. When i flip the switch on the car the battery holder( just 4 batteries, not the pack) start to get really hot and at first started smoking and melting. Anyone have any ideas on this?

rclynx

01-14-2009 11:26 AM

RE: Problem with Jato 3.3

You probably have a wire pinched under something or your RX is bad or your batteries are in wrong [:-] I bet its something [&:]

apax	01-14-2009 05:27 PM

RE: Problem with Jato 3.3

Yea maybe, im going to have to check out my wiring cuz i did take it apart to replace the top plate and had to move the wires around. I know its not the batteries, i made sure of that. I replaced the wire switch harness, and the battery holder wire and put in another receiver and it still does the same. But maybe it is a pinch wire or something like that. What is an RX?

Sonolin

01-14-2009 10:40 PM

RE: Problem with Jato 3.3

That does not sound good LOL. Rx = reciever (the thingy on your RC that the batts and servos plug into, that gets response from the transmitter (or tx)).

All times are GMT -8. The time now is 01:24 AM.