control throws
05-12-2004 | 09:20 AM
#1
Thread Starter
Senior Member
Joined: Oct 2003
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
From: TauntonSomerset, UNITED KINGDOM
control throws
Hi
Building my first pattern plane and was wondering what throws I should be using on my smaragd. The elevator I've used 1/4 balsa to cap the hinge point on it. The beveled it. I'm used to the high throws in 3D but will 2cm +/- be enough on the ailerons and elevator.
ALso wondering whether to top hinge the ailerons?? or is this just preference.
Building my first pattern plane and was wondering what throws I should be using on my smaragd. The elevator I've used 1/4 balsa to cap the hinge point on it. The beveled it. I'm used to the high throws in 3D but will 2cm +/- be enough on the ailerons and elevator.
ALso wondering whether to top hinge the ailerons?? or is this just preference.
