RCU Forums - specification for CG placement for the Home Run 46 model (Blackhorse)?

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Pattern Flying (https://www.rcuniverse.com/forum/rc-pattern-flying-101/)

- - specification for CG placement for the Home Run 46 model (Blackhorse)? (https://www.rcuniverse.com/forum/rc-pattern-flying-101/2639357-specification-cg-placement-home-run-46-model-blackhorse.html)

amram

02-09-2005 04:08 PM

specification for CG placement for the Home Run 46 model (Blackhorse)?

Hello All
Can anyone advise me on the vendor specification for CG placement for the Home Run 46 model (Blackhorse)?
Thanks in advance
Amram
http://www.f3a-israel.com

Bdsbob

02-17-2005 09:20 PM

RE: specification for CG placement for the Home Run 46 model (Blackhorse)?

I have the same airplane. The manual states that the balance should be 100 - 125 mm back from the leading edge. There is a diagram that shows the location of the C.G. The diagram has the distance measured back from the leading edge where it meets the fuselage - not at the wing tip.

I hope this helps.

:-)

All times are GMT -8. The time now is 01:21 AM.