Servo leads interference
#1
Senior Member
Thread Starter
Join Date: Apr 2003
Location: Chennai, INDIA
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
Servo leads interference
After more than a year of deliberation, I am putting it together. I've read a lot of useful posts on this web site and have decided the following for my setup.
OS 91 FS with pump, 14X6 APC
Hitec High torque rudder servo with pull-pull, Futaba Micro for the throttle,
individual Hitec high torques for ailerons and two Fut BB standard at the rear for elevators.
600 mah 5 cell pack.
Radio: Fut 6XAS PCM
This is the first time I am getting the servos at the rear and would like to know if I need some sort of filter to avoid RF interference. The distance from the servos to the RX is 28" to 30".
Thanks.
OS 91 FS with pump, 14X6 APC
Hitec High torque rudder servo with pull-pull, Futaba Micro for the throttle,
individual Hitec high torques for ailerons and two Fut BB standard at the rear for elevators.
600 mah 5 cell pack.
Radio: Fut 6XAS PCM
This is the first time I am getting the servos at the rear and would like to know if I need some sort of filter to avoid RF interference. The distance from the servos to the RX is 28" to 30".
Thanks.
#3
Senior Member
Thread Starter
Join Date: Apr 2003
Location: Chennai, INDIA
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo leads interference
Thanks Pauly,
Good to know, one less worry. However, I have heard that JR's lengthy leads do carry filters on their own. Could you please check if this is true?
Good to know, one less worry. However, I have heard that JR's lengthy leads do carry filters on their own. Could you please check if this is true?