Programming a switch for Take Off Trim on Spectrum Radio
#1
Programming a switch for Take Off Trim on Spectrum Radio
Hi All,
I have prop planes, especially warbirds, which require right rudder input to take off straight. Some WWII flight instruction films tell the pilot to put in 5 degrees right rudder and 5 degrees right aileron for take off to counter prop/engine torque. How to you set up a switch on a NX8 to have “Take Off Trim” on one position, and different set of trims for normal flying in the other position? Seem to remember doing this on a Optic 6 transmitter 15 years ago….
I have prop planes, especially warbirds, which require right rudder input to take off straight. Some WWII flight instruction films tell the pilot to put in 5 degrees right rudder and 5 degrees right aileron for take off to counter prop/engine torque. How to you set up a switch on a NX8 to have “Take Off Trim” on one position, and different set of trims for normal flying in the other position? Seem to remember doing this on a Optic 6 transmitter 15 years ago….
The following users liked this post:
captglvr (12-01-2021)