Programming 9C to activate 2 retract servos
09-23-2004, 10:34 PM
#1
Thread Starter
My Feedback: (11)
Join Date: Aug 2003
Location: Standish,
ME
Posts: 729
Likes: 0
Received 0 Likes
on
0 Posts
Programming 9C to activate 2 retract servos
I did a search and looked briefly through the manual and couldn't find what I wanted. I have a nose gear and main gear retract set-up. I want to plug each servo into individual channels (i assume ch. 5, 6), so that when I use a a two-way switch, the gear goes up and down. How would I program this in the 9C? I think it has something to do with using the flaperon func, but not sure. Thanks in advance.
