FC-28 problem - two elevator servos
04-10-2008, 04:53 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2002
Location: Semic, SLOVENIA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
FC-28 problem - two elevator servos
Hello!
I have FC-28 transmitter. How in ACRO program to set up two elevator servos (for each elevator one)? My servos channels (transmitter in MODE 2) are:
1. AIL1,
2. ELE1,
3. THR,
4. RUD,
5. ELE2,
6. AIL2,
My settings now are: FUNC: ELE2-F5, PMIX1 from 2 to 5 channel. But this solution is bad because any movement of F5 cause movement od ELE2. Very dangerous.
Setting FUNC: ELE2-F2 is also unsuitable because D/R than don't work on ELE2.
Thanks afterwards for answer. It is urgent for me.
Best regards.
Igor
I have FC-28 transmitter. How in ACRO program to set up two elevator servos (for each elevator one)? My servos channels (transmitter in MODE 2) are:
1. AIL1,
2. ELE1,
3. THR,
4. RUD,
5. ELE2,
6. AIL2,
My settings now are: FUNC: ELE2-F5, PMIX1 from 2 to 5 channel. But this solution is bad because any movement of F5 cause movement od ELE2. Very dangerous.
Setting FUNC: ELE2-F2 is also unsuitable because D/R than don't work on ELE2.
Thanks afterwards for answer. It is urgent for me.
Best regards.
Igor
