Pete737

Hello

I have my gear and gear doors on 2 seperate servos , operating 2 seperate mechanical valves.

Is there anyway to sequence this to operate on 1 switch?

I'm curious as to what others have done with this.

Thanks in advance. Peter

bruce88123

I think the jet guys use an electronic sequencer of some sort. Might check with them.

bruce88123

http://www.bvmjets.com/Pages/doorcyclr.htm
Here is one of the sequencers I was referring to.

ww2birds

My Feedback: (14)

We had a discussion on another thread about just these issues .. including how to use delays and other sequencing .. look here: [link=http://www.rcuniverse.com/forum/fb.asp?m=8142964]http://www.rcuniverse.com/forum/fb.asp?m=8142964[/link]

Dave