11.1 lipo in transmitter
i have a jr8103 trans with a spektrum mod in it. anyone if i can put a 11.1 lipo in it to power my trans, or will this burn something out .i see the 11.1 lipos for sale for these reasons ,but its more then the nicd that come with the radio . help please thx
|
RE: 11.1 lipo in transmitter
ORIGINAL: jpie028 i have a jr 8103 trans with a spektrum mod in it. anyone if i can put a 11.1 lipo in it to power my trans, or will this burn something out .i see the 11.1 lipos for sale for these reasons ,but its more then the nicd that come with the radio . help please thx You could also use an Eneloop battery or a LiFe battery pack. Both operate at a lower voltage. I have not had any issues with LiPo packs in any of my Transmitters, and I have been using these packs for several years. |
RE: 11.1 lipo in transmitter
thx but are you useing a spektrum mod in it or are you still on a channel thx again
|
RE: 11.1 lipo in transmitter
ORIGINAL: jpie028 thx but are you useing a spektrum mod in it or are you still on a channel thx again |
RE: 11.1 lipo in transmitter
So, look like they talk about this DIODE (volt reg) in this auction ?
http://cgi.ebay.co.uk/ws/eBayISAPI.d...=p5197.c0.m619 if you will install DIODE (its one way) tou will not charger this correct. Charger will not detect battery - only balancer. Total voltage will be not awailable |
RE: 11.1 lipo in transmitter
The TX Lipo I just bought came with JR, Futaba, and JST connectors on it.
I figure I can put the diodes in the JR lead, use the Futaba or JST lead for charging / voltage checking. (it's in my DX7 right now, might put it in my 8103) Right now I have no diodes in it, but I stopped the LiPo charge at 12.0 V when I charged it, rather than going to the full 12.6V. Yeah, the capacity might be a little less, but it helps keep a little heat out of the internal radio voltage regulators. In a linear voltage regulator (non-switching) all of the excess voltage gets turned into heat in the regulator. Keeping the voltage down a volt or two just helps keep things from getting too warm. |
RE: 11.1 lipo in transmitter
I charge through the Balancing Tap on the LiPo battery and I usually remove it from the Transmitter to charge it. The voltage of the battery is displayed correctly on the Transmitter's LCD display.
|
All times are GMT -8. The time now is 03:17 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.