Parallel servos
I'm running twin aileron servos in a bigger plane. There are four servos total. Two on each aileron. I have one set of servos plugged into a y and then running into separate channels in my receiver. The right aileron works great, but the left pair will not work together. I have tried both servos and they work by themselves, but once I put them together they chatter and don't center or start by themselves. I changed the extension on the outermost servo, and even tried a different y. I can't get it to work. The servos are all hitec hs-5645mg, and are all centering individually, and are rigged identical.
Is one of the servos bad? |
RE: Parallel servos
Is there a way to test the servos?
|
RE: Parallel servos
|
RE: Parallel servos
ORIGINAL: mnrcaerobat I'm running twin aileron servos in a bigger plane. There are four servos total. Two on each aileron. I have one set of servos plugged into a y and then running into separate channels in my receiver. The right aileron works great, but the left pair will not work together. I have tried both servos and they work by themselves, but once I put them together they chatter and don't center or start by themselves. I changed the extension on the outermost servo, and even tried a different y. I can't get it to work. The servos are all hitec hs-5645mg, and are all centering individually, and are rigged identical. Is one of the servos bad? I have rxperienced problems such as you have seen and replacing the Ybwith a good quality 20ga Y helped. I use JR Matchboxs or Furtaba Servo Sync, instead. If your Tx has enough channels, use Channel Mixing. A Smartfly device is also an alternative. Never use a Reversing Y.. |
RE: Parallel servos
I was able to mix with my futaba 10c
http://www.futaba-rc.com/faq/faq-10c-2_4ghz-q682.html Is there any way to mix with channel 9 and 10? I'm running dual elevator servos and am using 8 for that. |
All times are GMT -8. The time now is 07:50 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.