Question for hitec eclipse experts.....
 

I just got an Eclipse 7 for Christmas and I have been setting up some mixes for my Magic 3D. I set up a landing mix and a elevator to flap mix for square loops. The landing mix works fine but when I switch to the elevator to flap mix I get a slight up elevator and a slight right aileron movement with the sticks at the neutral position. What could be causing this??????

Question for hitec eclipse experts.....
 

Check the VR1 and 2 knobs and set them at center. That should clear up the aileron issue. I suspect there is a value set for ch. 2 (elevator) in some menu. You might try setting it up in another model menu so as to avoid the elevator movement.

Glen Merritt
Hitec USA

Question for hitec eclipse experts.....
 

Set up from scratch and the problem is gone. Must have had some value entered in one of the mixes that I didn't know about.