bigwill5686

Hey guys, i have a 4 tec 3.3 and i have already put on a buku pipe and a motor saver filter, and now i want a new header, what is ia good header for the 4 tec? Also i have heard of guys running an ofna .26 carb on there 3.3's for better power, is this true? i have 2 ofna .26's i can use for the carb.

oneofakindtrini

im not to sure abt that statement, because since a .26 is by far larger than what your 4-tec has it requires more air. so the air/fuel ratio would be off. but that is wha i wud say. i wudden try it.

bigwill5686

i dont know for a fact because i cannot remember where i saw it, but i thought that is what was stated, but then again because i cannot find it again it might just be something that i misunderstood

PrjctStrtFrce

My Feedback: (10)

Since you have the carb, why not just try it?

bigwill5686

yeah, i think i will try it this weekend, and if i blow the motor i can just start my big block(brent davis copy) project earlier then i thought

Nitro-4 Tec 3.3

comparing the buku whit traxxas dual chamber pipe which is better for top speed?