RCU Forums - replacing pull start with electric start

RCU Forums (https://www.rcuniverse.com/forum/)

- RC On Road Nitro Cars (https://www.rcuniverse.com/forum/rc-road-nitro-cars-242/)

- - replacing pull start with electric start (https://www.rcuniverse.com/forum/rc-road-nitro-cars-242/1449178-replacing-pull-start-electric-start.html)

dazzed

01-20-2004 02:42 PM

replacing pull start with electric start

can anyone tell me if i use a electric start(flywheel starter).....do i need to remove the pull start??????the reason i ask is i have removed the pull start and just replaced the cover...and my car wont start .....does the shaft for pull start add some compression...im a newbie and would thankful for any advice...thanx

rs_andy

01-21-2004 08:55 AM

RE: replacing pull start with electric start

Yes, you need to put the whole pull start back on for the engine to start, if you have taken out the shaft you have compression but air will be sucked in thru the hole left by the shaft instead of the carb so no fuel will be delivered.;)

dazzed

01-21-2004 12:49 PM

RE: replacing pull start with electric start

thanks for quick response to my question....:)

All times are GMT -8. The time now is 11:00 PM.