MY NITRO 4-TEC 3.3 CUTS OUT AT HIGH HELP!!!!
My nitro turns on fine... but when i accelerate gently it shuts off i've richend it, let it idle to warm up but it still shuts off. It also shuts off at high speed and there's a weird clicking sound but i dont know where it's coming from....help anyone...
|
RE: MY NITRO 4-TEC 3.3 CUTS OUT AT HIGH HELP!!!!
Try adjusting you Low end screw on the end of the carb slide trun it a 1/4 out just remember where you stated i just got a new 3.3 motor and it had the same problem
|
RE: MY NITRO 4-TEC 3.3 CUTS OUT AT HIGH HELP!!!!
Sounds like its too lean to me, first try richening up your high speed needle(turn counterclockwise 1/4 to 1/8 turn at a time) to see if that doesnt help anything, then go back and re-adjust the low speed needle. See if thatg helps ya out any. Hopefully this will :)
|
RE: MY NITRO 4-TEC 3.3 CUTS OUT AT HIGH HELP!!!!
it sounds as though your low end is to lean
|
RE: MY NITRO 4-TEC 3.3 CUTS OUT AT HIGH HELP!!!!
High speed needle to lean...;)
|
All times are GMT -8. The time now is 10:28 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.