I've got a clod on a gecho chassis, stock motors, sport esc. when frt or rear axle is unloaded, loaded axle gives up. If you climb steep frt axle spins, rear axle stops spinning. any ideas? Do I need quality esc, or are motors tired?

the motors are probably worn out,i'm not sure though,if you get new ones,go with integy 55t

Thanks, were do I find these motors? I was on there web site, could not find 55t

they are motors for a comm-trueing lathe so they might not be with the other motors.

No idea where they are on the site thought..

Thanks a bunch, I found them.