shaft problem
03-30-2009 | 04:44 PM
#1
Thread Starter
Senior Member
Joined: Mar 2007
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
From: Leeds, UNITED KINGDOM
shaft problem
Hi all
I have got a hovercraft with two 2 blade pusher props bolted together to make a four blade prop the problem i have it that the motors are geared down but the shaft that comes out of the gear box is two short really this causes the prop to wobble at high speed not very good or safe any tips on sorting this
I have got a hovercraft with two 2 blade pusher props bolted together to make a four blade prop the problem i have it that the motors are geared down but the shaft that comes out of the gear box is two short really this causes the prop to wobble at high speed not very good or safe any tips on sorting this
