Building an NLOS cannon Questions...
#1
Member
Thread Starter
Join Date: May 2011
Location: Jersey City,
NJ
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Building an NLOS cannon Questions...
Does anyone know the dimension of the 1/24 MLRS from FOV was looking at using the lower Hull as a basis for aRCNLOScannon, eyeballing it, looked to be about right to 1/16 as they only have the 18in rubber band treads. I know the lower chassis on the prototype is similar but smaller and narrower than the M3 bradley as the MLRS is longer than the bradley and done in a smaller scale I think this would look about right. Again i am not a rivet counter but looking for something that would give the correct feel and look. Please advise