SN VIDEO FUN
#1
Thread Starter
Senior Member
Joined: Apr 2007
Posts: 2,841
Likes: 0
Received 0 Likes
on
0 Posts
From: Escondido,
CA
Only one tanks blew a board in the making of this production!!!


Tigers don't like the water much....
http://www.youtube.com/watch?v=qY2rpo1MTt4
The Blitz[sm=shades_smile.gif]



Tigers don't like the water much....
http://www.youtube.com/watch?v=qY2rpo1MTt4
The Blitz[sm=shades_smile.gif]
#3
Thread Starter
Senior Member
Joined: Apr 2007
Posts: 2,841
Likes: 0
Received 0 Likes
on
0 Posts
From: Escondido,
CA
Ya that is amazing mine was too heavy and just collected the little pebbles!!!!
It was fun though and not back to the repair shop!!
The Blitz
It was fun though and not back to the repair shop!!
The Blitz
#4

ORIGINAL: blitzkrieg65
Only one tanks blew a board in the making of this production!!!


Tigers don't like the water much....
http://www.youtube.com/watch?v=qY2rpo1MTt4
The Blitz[sm=shades_smile.gif]
Only one tanks blew a board in the making of this production!!!



Tigers don't like the water much....
http://www.youtube.com/watch?v=qY2rpo1MTt4
The Blitz[sm=shades_smile.gif]
CUT!!!!
CLASSIC!
#5
Senior Member
Joined: Apr 2006
Posts: 2,161
Likes: 0
Received 0 Likes
on
0 Posts
From: Launceston, AUSTRALIA
The HL Tigers problem, if running in stock config is the board in the unflipped position has its components very close to the hull floor (and its only supposed to do puddle runs, not stream crossings lol). Your Tiger appeared to be really struggling on that run - low batts?
#7
Thread Starter
Senior Member
Joined: Apr 2007
Posts: 2,841
Likes: 0
Received 0 Likes
on
0 Posts
From: Escondido,
CA
ORIGINAL: wackywheelz
The HL Tigers problem, if running in stock config is the board in the unflipped position has its components very close to the hull floor (and its only supposed to do puddle runs, not stream crossings lol). Your Tiger appeared to be really struggling on that run - low batts?
The HL Tigers problem, if running in stock config is the board in the unflipped position has its components very close to the hull floor (and its only supposed to do puddle runs, not stream crossings lol). Your Tiger appeared to be really struggling on that run - low batts?
Na it turned out to be my rear idler wheel was pulling out, gotta do your PM especially before trying a river crossing! I'll have to go on your Aussie forum to look at some of those idler adjusters again it is time to lock it down!!!

The Blitz[sm=shades_smile.gif]
#8
Senior Member
Joined: Apr 2006
Posts: 2,161
Likes: 0
Received 0 Likes
on
0 Posts
From: Launceston, AUSTRALIA
Yeah extra link is sorta half too many, without it its tighter than "real", add one and its too sloppy for longterm, especially as tracks loosen up over time. Or did you mean the whole idler on its axle?
Theres some great innovative people around, especially for idler adjusters and custom suspensions - you already know where to look hehe
Theres some great innovative people around, especially for idler adjusters and custom suspensions - you already know where to look hehe



