Bearings
I seem to remember when searching for threads on modifiying the HL tiger I saw something about fitting ball races/bearings behind the drive sprockets into the lower hull to remove the play in the shafts.
Has any one one got the dimensions of the bearings? Are they standard buggy type bearings? Miggers:D |
RE: Bearings
8-9mm ID, 14-17mm OD, 5mm thick. Measure your shaft diameter first, I have a pile of bearings because of innacurate advice.
|
RE: Bearings
Cheers James.
I'll firk a sprocket off tomorrow night and get my vernier caliper out. Mark:D |
RE: Bearings
Spare bearings are like opinions :)
|
RE: Bearings
8-9mm OD???
All Heng Long gearboxes shafts have an outer diameter of 8 mm. Don't buy 9 mm inner dia. BBs, maybe HL OD is some 1/100 mm in excess, I've measured some of them at 8.07 and 8.08mm OD, but never 9mm. Regards |
All times are GMT -8. The time now is 11:40 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.