Zinger Spinner 6" Aluminum
#1
Thread Starter
Join Date: Feb 2002
Location: Beirut, LEBANON
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
Zinger Spinner 6" Aluminum
http://www2.towerhobbies.com/cgi-bin...?&I=LXLH43&P=7
Guys,
Anyone has any kind of opinions / experience with this spinner.??
Regards
Hisham
Guys,
Anyone has any kind of opinions / experience with this spinner.??
Regards
Hisham
#2
My Feedback: (10)
RE: Zinger Spinner 6" Aluminum
i used the 5.5" Zinger on a Nosen mustang, the Zinger spiners are the low end of alum spiners, the sheet metal screws along the perimeter that hold the cone on tend to come out. the back plate fatigued and cracked and needed a reinforcement plate.
I would not buy a Zinger.
I have used the Dave Brown 5" on my P-51's, this is better and DB also has a 6".
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXRX36&P=7[/link]
I would not buy a Zinger.
I have used the Dave Brown 5" on my P-51's, this is better and DB also has a 6".
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXRX36&P=7[/link]
#3
Thread Starter
Join Date: Feb 2002
Location: Beirut, LEBANON
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zinger Spinner 6" Aluminum
Kenair thanks for the reply and the link:
How about these Spinners :
http://www.kangkeusa.com/Accessories/spinners.htm
[]Hisham
How about these Spinners :
http://www.kangkeusa.com/Accessories/spinners.htm
[]Hisham