Warbird EVO 80 engine
#3
Thread Starter
Senior Member
My Feedback: (7)
Joined: Dec 2001
Posts: 3,453
Likes: 0
Received 0 Likes
on
0 Posts
From: Glen Robertson, ON, CANADA
ORIGINAL: t_burley
Roger thats a bad ass looking engine!
Roger thats a bad ass looking engine!
Roger
Forgues Research
#4

My Feedback: (59)
Joined: Jan 2002
Posts: 3,470
Likes: 0
Received 0 Likes
on
0 Posts
From: Bakersfield,
CA
wow, sounds like a winner. I may look you up in the
future here. I have seen your new site, and looked at these
new beauties. I think I see one that has my name on it
for a future project
future here. I have seen your new site, and looked at these
new beauties. I think I see one that has my name on it
for a future project
#6
Thread Starter
Senior Member
My Feedback: (7)
Joined: Dec 2001
Posts: 3,453
Likes: 0
Received 0 Likes
on
0 Posts
From: Glen Robertson, ON, CANADA
ORIGINAL: discusmike
What type of muffler fits the 80cc rear carb?do you have one that wraps around or is thin for warbird applications?
What type of muffler fits the 80cc rear carb?do you have one that wraps around or is thin for warbird applications?
Roger
#7
Thread Starter
Senior Member
My Feedback: (7)
Joined: Dec 2001
Posts: 3,453
Likes: 0
Received 0 Likes
on
0 Posts
From: Glen Robertson, ON, CANADA
ORIGINAL: t_burley
wow, sounds like a winner. I may look you up in the
future here. I have seen your new site, and looked at these
new beauties. I think I see one that has my name on it
for a future project
wow, sounds like a winner. I may look you up in the
future here. I have seen your new site, and looked at these
new beauties. I think I see one that has my name on it
for a future project
I'm told by the factory, with proper breakin, it will turn with the same setup, 6600rpm
Roger



