Jack Devine (and others)...Bimba Air Cylinders
01-13-2003 | 06:43 PM
#1
Thread Starter
My Feedback: (9)
Joined: Jul 2002
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
From: spring hill,
FL
Jack Devine (and others)...Bimba Air Cylinders
I've visited the Bimba site a few times and I'll be darned if I can find anything I'm looking for, that being aircylinders 1/2" to 3/8 Bore with strokes of 3" and greater, made of aluminum........
Am I not looking in the right areas?
Is their offline (paper) catalog different from their online catalogs?
Can you point me (using a link) to the correct area on their website to find what I'm looking for Jack?
Thanks in advance.......
P.S. I have the same problem (online) with the Clippard site........
Am I not looking in the right areas?
Is their offline (paper) catalog different from their online catalogs?
Can you point me (using a link) to the correct area on their website to find what I'm looking for Jack?
Thanks in advance.......
P.S. I have the same problem (online) with the Clippard site........
01-14-2003 | 05:18 AM
#2
Thread Starter
My Feedback: (9)
Joined: Jul 2002
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
From: spring hill,
FL
Jack Devine (and others)...Bimba Air Cylinders
Never mind....I bought a few from Ultra Precision....a bit pricey but better than searching catalog after catalog.........
01-15-2003 | 01:35 AM
#3
Junior Member
Joined: Oct 2002
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
From: Spartanburg,
SC
Jack Devine (and others)...Bimba Air Cylinders
I bought some 0074 cylinders from a local air/hydrolic company.
They were $16.50 each. I am building fowler flaps for my Ziroli P-38. It's a long term project, and i have only started cutting the parts. I really want the fowler flaps though.
They were $16.50 each. I am building fowler flaps for my Ziroli P-38. It's a long term project, and i have only started cutting the parts. I really want the fowler flaps though.
