View Poll Results: A poll
Voters: 131. You may not vote on this poll
Fliteskin Ta-152 H1
#254
Thread Starter
My Feedback: (29)
RE: Fliteskin Ta-152 H1
Yes Casey, I added like 40 parts more and re-drawn some to make them better fitting and more interlocking.
I picked up a DLE 55 rear exhaust for the prototype, eventually I will put a reduction gear/scale prop.
I think this will be the best Ta152 available so far.
JG
I picked up a DLE 55 rear exhaust for the prototype, eventually I will put a reduction gear/scale prop.
I think this will be the best Ta152 available so far.
JG
#256
Thread Starter
My Feedback: (29)
RE: Fliteskin Ta-152 H1
A few updates for the build: The aileron hinge line was modified, now is on the bottom so is a true frise type with the pushrod on top.
I will fly the prototype with a DLE55RA, very nice reliable engine, it will stick out a bit on the bottom, but I feel is more important to get the airplane flying with reliable power.
Once the first few flight are completed, I will continue searching for a small twin with matching power.
I added a few more parts to the wood kit, 2 servo trays and a switch and fuel/air port tray that fits behind the scale nose hatch .
And finally the molds for the canopy frame and gun hood are done!
More to come soon.........
J
I will fly the prototype with a DLE55RA, very nice reliable engine, it will stick out a bit on the bottom, but I feel is more important to get the airplane flying with reliable power.
Once the first few flight are completed, I will continue searching for a small twin with matching power.
I added a few more parts to the wood kit, 2 servo trays and a switch and fuel/air port tray that fits behind the scale nose hatch .
And finally the molds for the canopy frame and gun hood are done!
More to come soon.........
J
#257
Thread Starter
My Feedback: (29)
RE: Fliteskin Ta-152 H1
Unfortunately there is a glitch with RCU, pictures can not be up-loaded[:@]
But they can be seen here:
http://www.rcscalebuilder.com/forum/...14&PN=0&TPN=12
JG
But they can be seen here:
http://www.rcscalebuilder.com/forum/...14&PN=0&TPN=12
JG