The hull is on its way!
05-17-2006 | 08:39 PM
#1
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
From: Carlisle,
PA
The hull is on its way!
From corrospondance with Michael at Bowning Ship Yards:
"
I'm going to get a bus for a practical this afternoon so I'll
post it in about 10 minutes. ...
.... I haven't put a hard copy of how to rejoin it as I've already sent you
one and can send you another if you need. With the stuff you need you'll
also need a 10ml syringe with a blunt needle to pump resin into the
alignment tubes.
The box has glass matting, the 2 hull halves, pins to align it, 4 poly
carb rails (2 for the caprail area and 2 for the keel area and 16
stainless steel screws.
Cheers
"
SWEET!
does anyone know where I can get a really mini bottle of Champaine? LOL
"
I'm going to get a bus for a practical this afternoon so I'll
post it in about 10 minutes. ...
.... I haven't put a hard copy of how to rejoin it as I've already sent you
one and can send you another if you need. With the stuff you need you'll
also need a 10ml syringe with a blunt needle to pump resin into the
alignment tubes.
The box has glass matting, the 2 hull halves, pins to align it, 4 poly
carb rails (2 for the caprail area and 2 for the keel area and 16
stainless steel screws.
Cheers
"
SWEET!
does anyone know where I can get a really mini bottle of Champaine? LOL
05-17-2006 | 09:03 PM
#2
RE: The hull is on its way!
