Newbie with a Volcano EPX Pro problem...
07-20-2011, 05:26 AM
#1
Junior Member
Thread Starter
Join Date: Jul 2011
Location: , LA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Newbie with a Volcano EPX Pro problem...
First off, I am totally new to the hobby. After opening my Volcano, i took the battery out and charged it for approximately 3-4 hours...(i noticed it said to charge 6-8 but i couldnt wait). When I installed the battery and attempted to run the truck i have no communication between my radio and receiver it seems. I have followed the instructions (or at least I think I have) but I still cant get the wheels to turn or any response from the acceleration. When I power on the truck itself the wheels stay turned to the right. What am I doing wrong? Any help is greatly appreciated.
07-20-2011, 12:11 PM
#3
Junior Member
Thread Starter
Join Date: Jul 2011
Location: , LA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
RE: Newbie with a Volcano EPX Pro problem...
what do you mean by transmitter? if you mean the radio, then yes i put batteries in them. I have not binded them together yet tho. How would I go about doing that. Thanks
07-20-2011, 04:26 PM
#4
Senior Member
Join Date: Dec 2006
Location: Euless,
TX
Posts: 3,096
Likes: 0
Received 0 Likes
on
0 Posts
RE: Newbie with a Volcano EPX Pro problem...
Which volcano do you have? Because if you have the Volcano EPX standard then it comes with a 27Mhz Am radio in which case your transmitter or receiver could be bad.
