Hi, This is my first post on this site. This is my first Gas powered rc. I just became a dealer for red cat racing and I'm trying to figure out my tuning but I'm not even sure what the different idle screws are, what they do, and how much to adjust them. I hear that the engine tuning mod listed on the redcatracing site is very helpful as the manual is crappy. I have been trying to get on the page but I keep getting an error on the bottom half of the page that says: Error Occurred While Processing Request The value "" cannot be converted to a number. I was wondering if someone could copy the contents of that page and either email it to me at [email protected] or post it here on the site. It would be greatly appreciated. So far I get the car running with the glow igniter on it but when I take it off the engine stalls. The things brand new so the plug couldn't be bad already right? I don't want to adjust the screws yet because from what I read your not supposed to until the engines broke in correct? Anyway please post or email me the contents of that page. As a matter of fact though all of the mods on the redcatracing site dont seem to be working. I checked it on 3 different computers though and its all the same error.

Thanks

Go to the 4th page of this forum and read the post on engine tuning.

Oohh......not a good combination. [&o]

- bspate -