today i finally got my spur gears and i put them on and i started it up and i was tuneing the engine and i got it tuned ok then it quiet when i gave it gas so i tuned it all the way rich the leaned it out from there. Now the engine still runs at a higher rpm than normal when the servo is all the way back then about 15secs later it goes to idle is it a tuneing problem or something else? Its abrand new engine about 2 weeks old. PLEASE HELP!!!!

Thanks for your help.

yes thats tuning. What needles are you tuning? Low speed is out of whack.

i was tuning the high speed needle but the other day i was messing around with the low speed needle. How do i fix it

low end sounds too lean, richen it a full turn and see if it helps,

thanks ehroof i check back with you tomorrow to tell you how it goes

anytime bro, let me know how you make out