Help for a newbie?
10-24-2008 | 09:45 PM
#1
Thread Starter
Junior Member
Joined: Oct 2008
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
From: river grove, IL
Help for a newbie?
Hi All,
I am sitting here with my Landslide looking at a table full of parts and screws trying to put this thing back together. I have not had an RC truck in over 10 years so im new to this again. Heres my question: How do I remove the sprocket looking peice that is connected to the front dogbone? I see there is a pin but I was told that I need to remove an inner screw first. I purchased a 2.5 allen to remove that inner screw but cant get that to budge, any help would be appreciated.
I am sitting here with my Landslide looking at a table full of parts and screws trying to put this thing back together. I have not had an RC truck in over 10 years so im new to this again. Heres my question: How do I remove the sprocket looking peice that is connected to the front dogbone? I see there is a pin but I was told that I need to remove an inner screw first. I purchased a 2.5 allen to remove that inner screw but cant get that to budge, any help would be appreciated.
10-25-2008 | 12:40 PM
#3
Senior Member
RE: Help for a newbie?
the screw keeps that pin tight...I've never had them so tight I couldnt move them...I'm assuming your allen wrench fits in the screw snug...what u might do is take a box end wrench and use it for a lil more leverage....once you get that scew out you can take a small puch and drive out the pin and then the hub should come off..just be sure to put a lil blue locktite on that screw when you go back together....
