RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Redcat Racing Support (https://www.rcuniverse.com/forum/redcat-racing-support-427/)
-   -   need help with car (https://www.rcuniverse.com/forum/redcat-racing-support-427/5327430-need-help-car.html)

slide150 01-26-2007 05:31 PM

need help with car
 
my when i crank my car the wheels spin really fast and the car revs high i have all the settings back to factory settings so i could retune it. today i put on my tigerdrive and cranked it up and the wheels are doing what i said spinning could it be a bad clutch ? when i was running it before it wasnt doing that at all i even tried to play with the idle screw and it didnt work ne help would be apprieciated

thanx ahead

dan

slide150 01-26-2007 05:32 PM

RE: need help with car
 
oh i almost forgot when i roll the car forward i hear a clunk from the clutchbell

123michael 01-26-2007 06:08 PM

RE: need help with car
 
sounds like you need a new cluch spring;)dont get redcat.

123michael 01-26-2007 06:11 PM

RE: need help with car
 
http://www2.towerhobbies.com/cgi-bin...?&I=LXUR89&P=7 get these cluch springs they hold well

slide150 01-26-2007 06:14 PM

RE: need help with car
 
i think i'm going to buy the teflon clutch shoes to replace the spring and the hpi clutch bell to replace everything in the whole shabang

123michael 01-26-2007 06:17 PM

RE: need help with car
 
what car have you got

slide150 01-26-2007 06:18 PM

RE: need help with car
 
its an exceed rc xtreme but all of the parts are compatiable with the redcat tornado

slide150 01-26-2007 11:21 PM

RE: need help with car
 
has anyone used the teflon clutch shoes hpi #A886: [link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXVK12&P=7[/link] and will they fit with the hpi bell for the 2 speed

i just took my car apart the clutch is not round squared on the edges

ehroof 01-27-2007 08:07 AM

RE: need help with car
 
that clutch works but it gives a much higher stall rate so the clutch will not engage until higher rpm's but it does eliminate the spring. I switched back to the 4146x spring and stock shoes, just round the sharp edges with a file. the aluminum shoes work good with the hardened clutch bell.

slide150 01-27-2007 09:25 AM

RE: need help with car
 
ehroof if i do buy the teflon clutch should i set my gears to shift later because it enguages later

ehroof 01-27-2007 10:01 AM

RE: need help with car
 
no because the gears will still have to shift at the same rpm's, the clutch bell wont engage until higher rpms.

slide150 01-27-2007 01:22 PM

RE: need help with car
 
thanx man one more question if i dont use it u use the traxxas spring with the stock clutch shoes

ehroof 01-27-2007 01:54 PM

RE: need help with car
 
yes, 4146x spring with the stock redcat clutch shoes.


All times are GMT -8. The time now is 12:52 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.