|
RE: problem
ORIGINAL: MiniCwik Should get the HPI A886, it's what I have and has two sets of the spring/tension clips. Gold = high stall rate Black = standard stall rate http://www2.towerhobbies.com/cgi-bin...86&FVPROFIL=++ The HPI A885 is a good set too (but still has a wrap around spring) adjustable stall rate by cutting the clutch shoes. you dont adjust the stall rate by cutting the shoes, it comes with 3 holes to put the clutches in and depending what hole you put it in gives you the different stall rate. |
RE: problem
Okay, maybe not on our rides it's not necessary but I was speaking from manufacturer instructions:
http://www.hpiracing.com/graphics/instr/a885.jpg :) Cutting them reduces their weight, thuslly increasing engagement speed ;) |
RE: problem
wow, i have that in my hpi and never seen that, i read the instructions too, lol.
|
RE: problem
So I guess we do learn something new every day :LOL: :D
|
RE: problem
yes we do, :D
|
RE: problem
I know I do every day on this forum [8D]
|
RE: problem
so should i put it in the third hole ( or letter C in the instructions) for better low end?
|
RE: problem
ORIGINAL: MiniCwik Okay, maybe not on our rides it's not necessary but I was speaking from manufacturer instructions: http://www.hpiracing.com/graphics/instr/a885.jpg :) Cutting them reduces their weight, thuslly increasing engagement speed ;) BTW great info thanks |
RE: problem
Ok i finally replaced my clutch shoes and springs. What they looked like when i took them off.
http://i31.photobucket.com/albums/c3.../cluctch01.jpg Hpi racing clutch's spring was pain in the butt to keep two sides connected. I also tried to install 13/18 clutch bell but no luck. Couldnt figure it out. |
RE: problem
get the firestom clutch it fis coz i have it in my volcano.it is perfection nicely fitted in.:D
|
| All times are GMT -8. The time now is 03:24 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.