air cabin jr
#1
Senior Member
Thread Starter
Join Date: Oct 2006
Location: Barrie ont,
ON, CANADA
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
air cabin jr
ive looked and looked but can not find any information. has anyone built the air cabin jr from rcm plans. im looking for any info or photos that may be out there.
#2
My Feedback: (22)
RE: air cabin jr
I have the plans to it and it's on my build one day list. I too cannot find any info on it. I wish it were a 4 channel. Would be fun to put a small 4 stroke on it and do slips the length of the runway. Not sure how much dihederal would need to be taken out to make it fly right with ailerons. Also has a flat bottom wing. Hope you have the plans, sounds like RCM is not very quick on delivery. Laser Works offers it in a short kit.
Good Luck,
John
Good Luck,
John
#3
Junior Member
Join Date: Mar 2011
Location: Blue Earth, MN
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
RE: air cabin jr
GENTLEMEN
I built the "Air Cabin Jr" probably ten years ago. It was a very easy plane to fly and had a very good look. As a new pilot I found it easy to see and I could stay orientated when flying it. I will look for pix, I'm sure I have some. I will post if I can find them............
.KCØNPJ Gary
I built the "Air Cabin Jr" probably ten years ago. It was a very easy plane to fly and had a very good look. As a new pilot I found it easy to see and I could stay orientated when flying it. I will look for pix, I'm sure I have some. I will post if I can find them............
.KCØNPJ Gary
#6
Junior Member
Join Date: Mar 2011
Location: Blue Earth, MN
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
RE: air cabin jr
Yes, I built it as a three channel. If I build it again I will take the dihedral out of the wing and put in barn door ailerons. I think it would be fun
KCØNPJ Gary
KCØNPJ Gary