Hi all,

Sorry about the huge photos, I know there are some scratch build gurus in here and if you are one of them, perhaps you could possibly help this total noob out here, after all these years messing with fixed wing aircraft, I decided to try my luck at a scratch build drone, everything went ok until I reached the point of connecting a Rx (DS2500 Receiver, not sure of the brand) to an X-Racer F303 V3.1 Flight Controller, that is where I'm a bit confused. I've enclosed a few photos of the parts in question, I would appreciate very much if someone could shed some light on this, maybe "connect the dots" ?

Many thanks in advance

Biker

Bottom Side of Rx

Topside of Rx

Flight Controller top and bottom