wing joiner play
02-03-2004 | 09:32 PM
#1
Thread Starter
Senior Member
Joined: Jan 2004
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
From: FAIRMONT,
MN
wing joiner play
hey, i am building a Great planes piper cub 40 ARF... There is quite a bit of play in the wing joiner/wing joiner slot, is this ok? or, what should i do?
02-03-2004 | 10:24 PM
#2
Senior Member
My Feedback: (1)
RE: wing joiner play
Make sure the pieces in the wing are actually glued together.
If they are, then you can build up the joiner with a little 1/32 ply, but that will probably be too much. You could just be generous with the epoxy when you glue the wing together.
If they are, then you can build up the joiner with a little 1/32 ply, but that will probably be too much. You could just be generous with the epoxy when you glue the wing together.
