RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Kokkl
Showing results 1 to 6 of 6
Search took 0.02 seconds.
Forum: JetCat Turbine Direct Support
03-08-2020, 11:41 PM
Replies: 9
Views: 2,610
Posted By Kokkl

Morning all. Thought I would give you a...

Morning all.

Thought I would give you a update.

I foind the fault. The kero feed pipe into the burner had pulled out. So only se fuel was goimg into burner and other was spraying into the...
Forum: JetCat Turbine Direct Support
03-06-2020, 03:24 AM
Replies: 9
Views: 2,610
Posted By Kokkl

HI Dave. Version says 10.4E. Done complete...

HI Dave.

Version says 10.4E.
Done complete reset and tried again. But no luck.

Took a video, but do not know how to or even if I could upload.

Guess the best is to send engine in to Jetcat...
Forum: JetCat Turbine Direct Support
03-05-2020, 07:49 AM
Replies: 9
Views: 2,610
Posted By Kokkl

Hi Dave Thank you for the feedback. I...

Hi Dave

Thank you for the feedback.

I have tried the setting as sugessted, but no go. With Uaccel1 on 200 I do not even get a small flame.
Only on 250 above does a flame start inside.

But...
Forum: JetCat Turbine Direct Support
03-04-2020, 07:40 AM
Replies: 9
Views: 2,610
Posted By Kokkl

JETCAT 180NX not starting

HI ALL

Hoping someone can assist.
I have a Jetcat 180nx with v10 ECU but cannot get it to start.
The turbine ingintes and has a reasonable flame inside with the U-accel1 set at 250.
But as soon...
Forum: RC Jets
03-18-2019, 09:51 AM
Replies: 3
Views: 835
Posted By Kokkl

Thank you all. I have contacted turbine...

Thank you all.

I have contacted turbine solutions and will be shipping the turbine to them
Forum: RC Jets
03-17-2019, 01:33 AM
Replies: 3
Views: 835
Posted By Kokkl

Wren 180 compressor wheel

Hello.

Can anyonr assist with perhaps the part number of a Wren 180 compressor wheel.

Mine is chipped and need replacing.

I havr measure the inducer at 55mm and exducer at 75mm but cannot...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.